A. crimped
B. honed
C. flared
D. bent
E. none of the above

Advertisement

Related Mcqs:

  1. In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________________?
    A. d B. 1.25 d C. 1.5 d D. 1.75 d E. 2 d....
  2. In order to obtain bolt of uniform strength____________________?
    A. increase shank diameter B. increase its length C. drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread D. tighten die bolt properly E. all of the above...
  3. When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?
    A. shank B. head C. in the middle D. at the thread E. anywhere in the bolt...
  4. Resilience of a material is important, when it is subjected to________________?
    A. combined loading B. fatigue C. thermal stresses D. wear and tear E. shock loading...
  5. Stress concentration is caused due to_____________________?
    A. variation in properties of material from point to point in a member B. pitting at’points or areas at which loads on a member are applied C. abrupt change of section D. all of the above E. none of the above...
  6. In nitrated parts, the origins of the fatigue cracks will occur at__________________?
    A. surface B. just below the surface C. within the core D. could occur anywhere E. none of the above...
  7. For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
    A. ISO metric thread B. acme thread C. square thread D. buttress thread E. British Association thread...
  8. A key made from a cylindrical disc having segmental cross-section, is known as______________?
    A. wood-ruff key B. feather key C. flat saddle key D. gib head key E. hollow saddle key...
  9. Antifriction bearings are__________________?
    A. sleeve bearings B. hydrodynamic bearings C. thin lubricated bearings D. ball and roller bearings E. none of the above...
  10. Gear box is used___________________?
    A. to produce torque B. for speed reduction C. to obtain variable speeds D. to increase efficiency of system E. to damp out vibrations...
Advertisement